Move Close
Welcome to zx14ninjaform.com!

You are not logged in.
New Topic Reply
Next Page

Page: 1

Previous Page

Thread: ignition retard under boost 14r

Created on: 06/09/16 11:42 AM

Replies: 6

jdwilson4



Joined: 04/27/15

Posts: 5

ignition retard under boost 14r
06/09/16 11:42 AM

hey guys just wondering how many degrees everyone is taking out of there tunes for boost on the 14r ? im currently running 4 psi , 4 degrees retard and a/f or 11.0 to 1

Link | Top | Bottom

Rook


Rook's Gravatar

Joined: 03/28/09

Posts: 18972

RE: ignition retard under boost 14r
06/09/16 3:07 PM

Romans will be able to tell you the story on ignition timing. Is this Gen1 or Gen2? 11 is lean for the Gen1 according to what I have been told.



'08 MIDNIGHT SAPPHIRE BLUE flies out, full Tsukigi Cannon exhaust, BMC race filter, Muzzy's block off plates, Super Sprox 17t output sprocket, AFM 45t rear sprocket, EK zzz 530 chain, Gilles Tooling axle adjusters, PC5, Romans map, AT-200, Ignition Module, LCD-200, Speedohealer V4, Glow-Shift gauges, Illumiglow 210 mph clock faces, HM PLUS quickshifter, Factory Pro EVO Shift Star, RC's oil pump cover, Moto-D magnetic oil drain plug, MIT billet oil filler cap, Shorai 14A2 Lithium battery, Spiegler SS clutch and brake lines, HyperPro RSC steering damper, LighTech fuel tank cap, Vortex rearsets, lightweight mudflap bracket, FP Racing preload adjusters, Ohlins FGRT807 forks and KA544 shock, Carrazzeria Tri-R wheels, Bridgeport 90° valve stems, CZ 320mm front rotors, Galfer rear wave rotor, Pazzo levers, ProBots Dzus fasteners and many other bolts replaced with aluminum or Ti, Vortex mirror blocks, CRG bar end mirrors, LSL frame sliders, axle sliders, billet bar ends, 2WheelWorkz muffler

Link | Top | Bottom

Romans


Romans's Gravatar

Location: Toronto,ON

Joined: 02/13/09

Posts: 5913

RE: ignition retard under boost 14r
06/09/16 4:31 PM

Pull zero with 4 psi

Pull two with 6 psi

Pulled 4 with 8lb

Link | Top | Bottom

jdwilson4



Joined: 04/27/15

Posts: 5

RE: ignition retard under boost 14r
06/09/16 7:01 PM

thanks for the replys, im aiming for the safest tune possible right now even at the expense of horsepower. my goal over the winter is to run water/meth or intercooler or both.

Romans i did not get your message till after i purchased a kit but i did end up going with RCC turbo, Richard was fantastic helping me with many issues i ran into with the install.

Link | Top | Bottom

jdwilson4



Joined: 04/27/15

Posts: 5

RE: ignition retard under boost 14r
06/09/16 7:09 PM

Also would you guys mind looking over my ign table and my a/f targets? i attached the images below




* Last updated by: jdwilson4 on 6/9/2016 @ 7:10 PM *

Link | Top | Bottom

Romans


Romans's Gravatar

Location: Toronto,ON

Joined: 02/13/09

Posts: 5913

RE: ignition retard under boost 14r
06/10/16 6:48 AM

thanks for the replys, im aiming for the safest tune possible right now even at the expense of horsepower

You are very safe timing wise. AFR table very safe but you are running way to rich in area's off boost IMO. Are you running all your fueling adjustments through your ECU ?

Link | Top | Bottom

jdwilson4



Joined: 04/27/15

Posts: 5

RE: ignition retard under boost 14r
06/10/16 11:51 AM

Romans,

Im also running the standard rising rate fmu provided in the rcc turbo kit, other then that everything is done through woolich racing ecu.

Could you possible send me a excel of you autotune targets ? The reason i went so rich at part throttle was i was afraid of part throttle knock boost seems to come on very early and with very little throttle openings

Link | Top | Bottom


Welcome to zx14ninjaform.com!
 
New Topic Reply
Next Page

Page: 1

Previous Page

New Post

Please login to post a response.