So i decided to take a small risk and bought Sargent seat for C14 that had been in a 2009 GRT1400. I compared my oem seat to it and it matched quite good except the middle bracket.

Now it is installed into bike and here is what I did in order to fit it:

- Drilled the C14 bracket screws out -> could not get 10 mm wrench to hold the bolt
- Drilled the plastic raised parts away so that the center bracket from my ZZR could fit
- Installed center bracket with new set of screws (M6)
- Had to cut small amount of material off the rear damper rubbers, this is probably because I have the givi mounting plate installed.

Few pics:

Red circle points the modifications I made:

I

* Last updated by: djoh on 8/23/2016 @ 5:09 AM *

Looks o so comfy and COOL at the same time!

Few pictures more:

That looks pretty darn good.

Sargent seat is one comfy seat.

You could always get the Corbin too but it definitely takes a while before it starts to break in and even with break-in it can still create some pressure points for those lonnnnnnnnng rides depending on your body type.