Hey, Hub.......I've been thinking about making my own electrical contacts to hook up my Autotune module because I would rather not tap or cut the wire I intend to draw power from. The power source will be the conector under the seat for the license plate lamp. I was thinking of cutting out a tiny metal tab that could slide in the socket with the wire from the Autotune attached with a screw. It would then be taped up to hold it in place and insulate it. There is a positive and a negative wire in the connector so I am thinking it should work for both the power and the ground of the Autotune.
I was looking at an electrical wall socket in the hardware store and I see it has metal contacts that already have a screw to attach a wire. Think it would work if I removed those and cut them down to fit the connector under the seat? Any other suggestions?