Installation:
1. Locate the Bonneville PRO in the rear trunk area. Secure with double sided tape or Velcro®.
2. Route long part of the harness forward along the left side of the bike. Locate and unplug the stock speed
sensor plug. Plug the Bonneville PRO in line of the speed sensor by connecting the male and female
connectors to the stock speed sensor plug.
3. Locate the Blue/Yellow wire coming out of the left side of the ECU (This wire is on the top row about six
wires in from the left). Cut this wire about 2 inches from the ECU.
4. Crimp the provided female bullet connector on the Blue/Yellow wire that goes forward toward the
speedometer.
5. Crimp the male bullet connector on the Blue/Yellow wire that goes to the ECU.
4. Plug the Blue and Green wires from the Bonneville PRO into the corresponding bullet connectors that you
just installed. (The Green wire should be connected to wire going toward the speedometer and the Blue
wire should be connected to the wire going into the ECU)
Pg
08 zx14se Brocks CT Duals, Brocks street map, Driven 16/43 sprockets,EK ZZZ Chain,MRA Windscreen, Roaring Toyz Diamond Cut Grips Pingel Elec shifter, Hyper-Pro RSC Damper, BlackChrome Wheels, Sargent Seat,Factory Pro Velocity Stacks,PCIII USB,Bonneville Pro, TPX Radar/Laser Detector, TPX Laser Jammer, Goodridge Shadow series braided lines front and rear, Rifleman 1/5 turn throttle, Fusion LED Stage IV Kit, DDM HID's 10,000k