Thanks, Ive tried to think of other ways to weld on a vertical brace, but the only part of the bike thats lower, is the Swingarm, and obviously since it moves differently than the seat, this wouldnt work. My other idea was extend the bar under the tail, so for the GoPro to bounce downward, it would have to push the other end of the bar up, and it would be attached to the tail, so it couldnt move, and vise versa. You can also tell in the Short Arm video, I had to make a bracket to hold my exhaust on as well. lol
I need to see if I can use the gopro bracket with the rear peg still on the bike. I had a couple local people say that I should make these and sell them. But, personally, unless its a ZX14 or 07 R1, Id want your bike here so I could make the bracket to fit correctly. Some of the tabs I line up while on the bike, and tack weld them, then take it off the bike, and finish all the welds. I dont really measure, I just hold it where I need it, and start welding. lol
* Last updated by: Kolk1 on 6/6/2012 @ 11:41 AM *
New build, Fresh re-plated block, Velocity Racing Turbo kit, JE Turbo pistons, P&P Head, and a whole lot more. Current on 8.5psi.
2013 White ZX-14R, Full Hindle exhaust, Puig DB screen, HIDs, drop pegs, bar risers, and so on, setting it up for touring.