So I'm trying to figure out an issue with my Bking. The Suzuki forums have been little help. I was hoping one of the Kawi guys could suggest something. I replaced my cutch, line and just rebuilt the slave and bled the system. The clutch still does not disengage far enough to release when in gear? I'm lost. I took the clutch cover off and could see that the plate move, but not far enough. When I put the new clutch in I couldn't get the pressure plate to mesh with the basket without taking off the slave cylinder. It appeared the rod was sticking out too far to let the pressure plate seat properly. Still is the same. What is causing this? I don't see any alignment marks that would indicate that the pressure plate needs to line up with a certain spot on the basket. So far I've replaced the clutch, clutch line and rebuilt the slave. Anyone?
Bill
13 ZX14R
08 BKing
* Last updated by: BillAz31 on 9/26/2015 @ 10:08 AM *
13 ZX14R
08 BKing