Which direction do you turn the lower adjustment screws to move the high beams left or right.

There are two knobs/screws one for each set of beams. Am sure you turn in different directions for each different bank>

Which direction to get left or right movement for each screw? Manual just says were the adjuster is, now which way to move it which is very stupid.

Okay...first...the headlamps ALL move together...meaning...One set of screws for one assembly,and for the other.Each assembly has a vertical(the one up in the corner)...and a horizontal(the one at the inner bottom).To get the horizontal adjusted 'off to either side'...you turn the LOWER inner screw....BUT...to get BOTH assemblies pointing the same 'off center' direction...the screws need to be turned..on the right side lamp...CC to adjust the beam to the right.On the left assembly,you turn the lower inner bolt on that assembly CLOCKWISE to adjust to the right.The vertical on BOTH sides is turned CLOCKWISE to raise,CC to lower.THIS will adjust BOTH highs and LOWS...they are NOT independent.

They are exactly like adjusting your car lamps...(screws either pulling the lamps,or 'pushing' the lamps...depending on which way you are turning.

Because the screw's threads are all a standard design,you have to reverse the turning from one side to the other depending on what you want...but not for the vertical adjustment...those both raise or lower turning in the desired direction.CC to lower,Clockwise to raise.

* Last updated by: Grn14 on 7/9/2012 @ 9:28 AM *

Thank you!