PCIII problems need some help.

Thread: PCIII problems need some help.

Created on: 03/21/10 05:33 AM

Replies: 1

elfasto14neo

Joined: 03/21/10

Posts: 2

PCIII problems need some help.
03/21/10 5:33 AM

Just bought a PCIII for an 07 14. I uploaded proper map, installed as instructions said.
The problem occurs after riding the bike for about 10-15 mins (or when bike warms up) bike starts to cut out and die. I even had the wonderful experiance in pushing the bike thru an intersection. After the bike cools down just a little bit it starts back up, but starts to cut out again down the road. The bike is not over heating nor does the temp gauge read hot. The ground wire on the PCIII is still intact. The mods are flies out, shorty GP pipes.

Link | Top | Bottom

scottjkyl

Location: east jordan,mi

Joined: 06/26/09

Posts: 1851

RE: PCIII problems need some help.
03/21/10 6:30 AM

mine did the same thing come to find out i didnt have the main harness snapped all the way into the plug thats attached to the bike, it was sliding in and out of connection. so check your harrness connections.

08 zx14se Brocks CT Duals, Brocks street map, Driven 16/43 sprockets,EK ZZZ Chain,MRA Windscreen, Roaring Toyz Diamond Cut Grips Pingel Elec shifter, Hyper-Pro RSC Damper, BlackChrome Wheels, Sargent Seat,Factory Pro Velocity Stacks,PCIII USB,Bonneville Pro, TPX Radar/Laser Detector, TPX Laser Jammer, Goodridge Shadow series braided lines front and rear, Rifleman 1/5 turn throttle, Fusion LED Stage IV Kit, DDM HID's 10,000k

Link | Top | Bottom