The VSS (engine speed) lead and the Rostra VSS are not working together on this bike, so I bought a magnetic coil/magnet pickup setup for the speed lock on. The magnets are very small and light, about 1/2" x 1/4".
I was thinking of epoxying them to washers - with a very short arm extension to be able to center them 180 degrees apart ( it's a 5 bolt rotor pattern- :( ). I need 2 total, then mounting them on the inner bolts on the brake rotor, which is just a few inches from the center of the wheel.
Question is do you think that location and amount of weight will throw off the balance of the wheel or?
Thanks.