I'm late to the Party of removing my Middle/lower fairing combo. I watched Brock's video but some items not covered-like All these different sizes of push-pin Revits. I took them off without paying any attention to them. OEM parts fiche show 6 different sizes used in the fairing. I've found 4. And I finally figured out where they all go. Getting old and forgetful is the pits.
This morning I pulled them out and checked depth of each pin.
Short ones go above the fender and those are different in width and appearance.
I took a photo before removing the push-pin Revit at the rubber panel and note its rough-finished head.
I had switched 2 pins and noticed one was falling out and the other was too tight (lengths were different).
These push pins are very expensive from Big Kawa. $2.30-$3.80 each.
* Last updated by: doubleD on 10/8/2019 @ 6:39 PM *