Bar risers on ZX14R?

Fiction14

Location: East Coast

Joined: 05/22/13

Posts: 88

RE: Bar risers on ZX14R?
06/10/14 5:20 PM

I just installed a set of genmars on my 14 Zx14r, they bolted up with no problems.

2014 ZX14R, Brocks Penta carbon Exhaust Zero Gravity Marc 1 Windscreen DNA High Performance Air Filter Power Commander V Ivan's ECU Flash (Recommended) T-Rex Frame Sliders Yoshimura Fender Eliminator Pirelli Diablo Rosso III Front and Rear Tires Supersprox Rear Sprocket Powerbronze Lens Shields Puig rear hugger Faster, faster, faster, until the thrill of speed overcomes the fear of death.

Link | Top | Bottom

BobZ

Location: Marineland FL

Joined: 03/09/17

Posts: 190

RE: Bar risers on ZX14R?
03/29/17 7:21 PM

I looked at the them both and is the only difference between the Helibars and Genmars are .25" (Genmars are 1" rise & Helibars .75")? Quality & ease of installation comparable?

Ride safe, but fast.

Link | Top | Bottom

cruderudy

Location: AMR

Joined: 08/15/12

Posts: 1963

RE: Bar risers on ZX14R?
03/29/17 8:29 PM

very simple unless the forks have been raised a bit to help with steering. If so you have to drop them back to stock to fit the riser. I think 1 in is all you can lift the bars without the fluid cups hitting the wind screen. I have the 1 in riser and the Buell pegs to lower 3/4 in.

Perfectly Set up '06 dead and gone
New BBW '14 14R

Link | Top | Bottom

BobZ

Location: Marineland FL

Joined: 03/09/17

Posts: 190

RE: Bar risers on ZX14R?
03/29/17 9:00 PM

Cool, I have a pretty much stock '14R ABS so the Genmars should work. I just put a pair of Knight Designs lowering pegs (1 3/8") and they help a lot.

Ride safe, but fast.

Link | Top | Bottom

BobZ

Location: Marineland FL

Joined: 03/09/17

Posts: 190

RE: Bar risers on ZX14R?
03/29/17 9:02 PM

Cool, I have a pretty much stock '14R ABS so the Genmars should work fine. I also just installed a pair of Knight Design lowering pegs (1 3/8") and they help a lot.

Ride safe, but fast.

Link | Top | Bottom

WillsZX14R