I'm moving this to the "general" section so more people might see it. I got a new wellnut from Kaw. 2 problems right off the bat. #1 No "bump out" in the middle, so it fits loose in the hole and spins freely. #2 Because it isn't squished in the middle, it's also longer. That means the bolt doesn't reach the threads with 2 panels in between. So now the wellnut spins freely in the hole, and the bolt doesn't reach the threads no matter how hard you push. There's no way to tighten it! I wrapped some electrical tape arount it so it fit tight, but the bolt still can't catch the threads. After an hour of trying to hold the back of the nut and squish it far enough for the bolt to catch I gave up that idea. Next I shave off as much plastic from the black battery cover, and try again. Still no go, so I shave some rubber off the wellnut flange, and the bolt FINALLY touches thread. 3 hours to replace 1 @^%*^$ wellnut!