Move Close
Welcome to zx14ninjaform.com!

You are not logged in.
New Topic Reply
Next Page

Page: 1

Previous Page

Thread: Starting Issue

Created on: 07/24/12 04:57 AM

Replies: 6

jeffreyb



Joined: 10/07/09

Posts: 24

Starting Issue
07/24/12 4:57 AM

I have an 09 ZX 14. For a while now, when I hit the starter there is a hesitation before the starter kicks in. Yesterday I hit the starter and the motor started to turn over, then stopped, then the fuel pump ran again as if I had turned the key off and on, then the motor turned over. I shut it down and tried to start again, and worked fine that time. Any ideas???

Link | Top | Bottom

hagrid


hagrid's Gravatar

Location: pittsburgh

Joined: 02/16/12

Posts: 2212

RE: Starting Issue
07/24/12 1:07 PM

Is this the battery that came with the bike? Maybe getting soft.



Yoshis!! GO NINJEE!!!

Fat chicks at Wal-Mart: NOT RECOMMENDED

Link | Top | Bottom

audioboyz


audioboyz's Gravatar

Location: Washington,Pa

Joined: 03/25/12

Posts: 531

RE: Starting Issue
07/24/12 1:46 PM

My 09 battery is getting a little worn.Going to change it over the winter.
Craig



Kawasaki is the worlds guardian of high performance 09 ZX-14 Monster Edition,Brocks Alienhead,PCV,-1 front sprocket, 43 Vortex rear sprocket,Speedo DRD speed calibration device,CF Ram Air Tube Covers

flies out,Zero Gravity tall smoked,LSL handlebar kit,K&;N Filter Concours seat,pollution block off plates installed,Dynotuned 175HP 104FT LB's TQ

2011 Mustang GT 6-Speed 5.0

Link | Top | Bottom

jeffreyb



Joined: 10/07/09

Posts: 24

RE: Starting Issue
07/25/12 4:41 AM

I put a new battery in about a month ago. Checked terminals and connectors. All look good. This issue has been going on for at least 7 months. Unfortunately the dealer down where I bought the bike sucks and I won't bring the bike in to them.

Link | Top | Bottom

zxtor



Location:

Trondheim, Norway

Joined: 05/22/12

Posts: 7

RE: Starting Issue
07/27/12 2:36 AM

I had a similar problem on my ’08, turned out to be the neutral lamp and gear position sensor that was the culprit.
I cleaned it and has been ok since. Also, sometimes when the starter motor stopped turning, the neutral lamp would flicker.

Link | Top | Bottom

helvio46



Joined: 07/28/12

Posts: 1

RE: Starting Issue
07/28/12 2:03 PM

hello friends,im new here i would like to know if immo ecu from 2007 can fit on 2006 zx14,cheers

Link | Top | Bottom

COOTER


COOTER's Gravatar

Location:

South West Florida

Joined: 04/27/11

Posts: 1342

RE: Starting Issue
07/28/12 10:37 PM

hello friends,im new here i would like to know if immo ecu from 2007 can fit on 2006 zx14,cheers
Yes a 2007 ECU will work on a 2006!



Team panda (ride safe ride sober)

Link | Top | Bottom


Welcome to zx14ninjaform.com!
 
New Topic Reply
Next Page

Page: 1

Previous Page

New Post

Please login to post a response.